Hilti VC 150-6 X Mode D'emploi page 13

Max. additional load
Container capacity
Effective dust capacity
Effective water capacity
Air temperature
Automatic filter cleaning
AC frequency
Mains connection (type)
Protection class
Protection class
5 Use of extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate
cross-section. Otherwise the performance of the appliance may be affected and the cord may overheat.
• Regularly check the extension cord for damage.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
6 Before use
DANGER
Electrical hazards. Fatal or serious injury may result if the vacuum cleaner is not correctly connected to the
electric supply.
▶ Connect the vacuum cleaner only to a properly earthed/grounded power source.
CAUTION
Risk of injury presented by the appliance running away out of control. The vacuum cleaner may run
away out of control if the wheel brakes are not engaged.
▶ Engage the wheel brakes so that the vacuum cleaner stands securely.
6.1 Operating the appliance for the first time
Select the dust bag that is best suited to the material to be collected (mineral, wood) and the nature
of the application (dry/wet). → See the section headed "Instructions for use"
1. Open the two catches.
2. Lift the suction head off the waste material container.
3. Remove the accessories from the waste material container and packaging.
4. Insert a dust bag in accordance with the instructions.
5. Fit the suction head on to the waste material container and close the two catches.
8 English
VC 150-6
55 lb
(25 kg)
4 liq. gal
(15 ℓ)
33 lb
(15 kg)
2 liq. gal
(9 ℓ)
14 ℉ ... 104 ℉
(−10 ℃ ... 40 ℃)
sensor-controlled
50 Hz ... 60 Hz
X version SJTOW 3/12 AWG
XE version SJOW 3/16 AWG
I
IP X4
VC 150-10
55 lb
(25 kg)
8 liq. gal
US
(30 ℓ)
75 lb
(34 kg)
6.0 liq. gal
US
(22.8 ℓ)
14 ℉ ... 104 ℉
(−10 ℃ ... 40 ℃)
sensor-controlled
50 Hz ... 60 Hz
SJTOW 3/12 AWG
SJOW 3/16 AWG
I
IP X4
2268128
*2268128*
US
US