Start-Up; Operation; Selecting A Light Colour; Selecting The Colour Change - LIVARNO LUX LED MOOD LIGHT Mode D'emploi

Start-up

Colour changing LED mood light
Place the LED mood light
solid surface.
Connect the mains plug
the available mains voltage matches the required
operating voltage of the product before use
(see „Technical Data").
The LED mood light is now ready for use.
Remote Control (Fig. C)
Remove the insulating strip
battery and the battery compartment
16
on the remote control
Note: Please note, the remote control uses
infrared light. The signal cannot be transmitted
„around the corner" as radio waves do. Light-
tight objects may not be located between the
infrared diode and the light.
14

Operation

Use the remote control
or different colour change programs (Fig. A):

Selecting a light colour

Press one of the colour buttons
button to select a colour corresponding
7
with the button colour.
Press the button
the brightness.
Press the button
light.

Selecting the colour change

: brighter
: dim
5 x R: selects the desired colour
5 x G: selects the desired colour
5 x B: selects the desired colour
on a level and
1
to a socket. Verify
20
between the
17
13
before use.
2
to select a light colour
2
or the W
12
to gradually increase
3
to gradually dim the
4
Start-up / Operation / Cleaning and care
1 x W:
FLASH button:
STROBE button:
FADE button:
SMOOTH button:

Switching off the light

If the LED mood light
the OFF button
the last colour or colour change selected will
be used when switching the light on again with
the ON button
6
However, if the LED mood light is disconnected
from the mains supply by unplugging it from
the socket, the LED mood light will always light
up white when switched on again.
Changing the battery (Fig. C)
Change the battery
remote control
2
mood light no longer responds to the remote
1
control.
Pull the battery compartment
remote control
2
Remove the battery
Insert the new battery
Only use the type of battery
chapter „Technical Data" and note the polarity
when inserting the battery. This is shown on the
back of the remote control
Slide the battery compartment
remote control
2
Cleaning and care (Fig. B)
Switch the LED mood light
Remove the mains plug
before you clean the light.
Clean the LED mood light
control with a dry, lint-free cloth.
2
Remove the glass ball
by holding on to the lamp base
19
selects the desired colour
rapid colour change
slow colour change
flowing colour change
slow, flowing colour change
is switched off with
1
on the remote control
5
.
when the range of the
16
noticeably declines or the LED
out of the
15
.
.
16
.
16
specified in the
16
.
2
back into the
15
.
off.
1
from the socket
20
and the remote
1
from the lamp base
18
and
19
GB/IE/NI
,
2
9