Start-Up; Assembly; Switching The Lamp On / Off; Adjusting The Reflector Or Spotlight - LIVARNO LUX 14100308L Instructions D'utilisation Et Consignes De Sécurité

Start-up / Replacing the bulb / Maintenance and Cleaning

Start-up

Assembly

14100602L:
Push the rods through the base
12
Place the washer
13
the nut over the thread and tighten with the
15
tool .
16
Affix the base mat
the base .
5
Attach the reflector
Turn the reflector
1
14100402L:
Carefully insert the bulb
ing the suction cup
clockwise. Ensure that it is properly seated.

Switching the lamp on / off

14100308L, 14100602L:
Connect the mains lead
Plug the mains supply
14100602L) or the mains plug
14100508L) into a properly installed mains
socket.
Switch the lamp on or off using the ON / OFF
switch .
4
Adjusting the reflector
or spotlight
Note: only adjust the reflector
with the light switched off.
Allow the light to cool off completely.
14100308L:
Bring the lamp arm
Angle the reflector
using the adjustment lever
14100402L:
Bring the lamp arm
Adjust the spotlight
26 GB
.
5
, toothed washer and
14
to fit the underside of
17
to the tube .
1 12
into the desired direction.
into the socket us-
9
and secure with a ¼ turn
10
to the mains supply
6
(model 14100308L,
7
(14100402L,
11
or the spotlight
1
into the desired position.
3
to the desired angle
1
.
2
into the desired position.
3
to the desired position.
8
14100508L:
Align the spotlight
lever .
2
14100602L:
Turn the reflector
Angle the reflector
Replacing the bulb (14100402L)
CAUTION! RISK OF ELECTRIC SHOCK!
First unplug the mains plug
CAUTION! DANGER OF BURN INJURIES!
Allow the lamp to cool down completely.
Use the included suction cup
bulb . Carefully press the suction cup
9
onto the bulb
Remove the bulb
socket with a ¼ turn counter-clockwise.
Only use lamps with a GU10 base and a maxi-
mum output of 3 Watt.
. Carefully insert the new bulb into the socket
7
using the suction cup
¼ turn clockwise. Check for correct seating.
Plug the mains plug

Maintenance and Cleaning

Note: The device is maintenance-free.
The LEDs are not replaceable (model 14100308L /
14100508L / 14100602L).
CAUTION! RISK OF ELECTRIC SHOCK!
First remove the mains plug from the socket.
8
CAUTION! DANGER OF BURN INJURIES!
Allow the lamp to cool down completely.
CAUTION! RISK OF ELECTRIC SHOCK!
For electrical safety, never clean the light with
water or other liquids, or immerse it in water.
Do not use solvents, benzene or similar sub-
stances. They could damage the light.
Unplug the mains supply
plug from the socket.
11
Only use a dry, lint-free cloth for cleaning.
using the adjustment
8
to the desired position.
1
to your liking.
1
from the socket.
11
to change the
10
to do so.
9
by unscrewing it from the
9
and secure with a
10
into the socket again.
11
or the mains
7
10