Back Angle Adjustment - Quickie QRI Mode D'emploi

Q R I
10 11
Adjustment
1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 hex bolts (D)
by using a 10 mm (Metric M6 Hex Head) wrench
2. With the armrest assembly in the receiver, press firmly on the outside of the receiver
(E).
11
3. Maintain pressure on the receiver and re-tighten two of the hex bolts.
4. Remove the armrest assembly and re-tighten the remaining two hex bolts.
5. The armrest will fit firmly in the receiver and lessen any noise that may result from
vibration.
F. BACK ANGLE ADJUSTMENT
Adjusting the Back Angle
1. Release the backrest by pulling the release cord (F) with a simple, short force.
2. While maintaining tension on the release cord, rotate the backrest to the desired angle
or to the folded down position.
3. Lock the backrest in place by releasing the cord and allowing the pins (G) to engage in
the nearest hole (I) of the backrest bracket (H).
CAUTION– Be sure the pins (B) are fully engaged through the backrest bracket (H) on both sides of the
chair. Test the backrest to be sure it is locked before use.
CAUTION – When changing the back angle of the wheelchair both the left and right angle adjustable back
bracket must be in the same hole position before the wheelchair is to be used.
Non-folding back instructions
1. Remove backrest bracket bolt (E).
2. Rotate the backrest to the desired angle.
3. Align desired backrest bracket hole with seat frame opening.
4. Reinsert bolt and tighten.
CAUTION – When changing the back angle of the wheelchair both the left and right angle adjustable back
bracket must be in the same hole position before the wheelchair is to be used.
Backrest Angle Preset Plugs
The preset plugs allow you to unemploy the backrest bracket holes you do not wish to use.
This allows the backrest to automatically lock into your desired angle position after unfolding.
1. Determine which backrest bracket holes you do not want to use.
2. Insert plugs (F) into the predetermined holes from the chair side of the bracket (G).
3. To ensure the backrest will lock in the folded position, do not insert a plug into the
lowest hole position (H).
122143 Rev. C
10 .
12 13
12 13
14
15
14 15
18
X. SET-UP & ADJUSTMENT
10
D
11
E
12
G
H
F
I
Non-Folding Back 14
E
15
F
G
H
13
G