Preparing The Remote Controller - dji AGRAS T20 Guide De Démarrage Rapide

3. Preparing the Remote Controller

Charging the Batteries
Charge the external Intelligent Battery using the charging hub and AC power adapter. Charge the internal battery of the remote
controller using the USB charger and USB-C cable. Fully charge the batteries before using for the first time.
Charging Hub
Mounting the External Battery
Press the battery cover release button on the back of
1
the remote controller to open the cover.
Insert the Intelligent Battery into the compartment and
2
push it to the top.
Close the cover.
3
To remove the Intelligent Battery, press and hold the battery release button, then push the battery downward.
●
Mounting the 4G Dongle and SIM Card
Only use a DJI-approved dongle. The dongle supports various network standards. Use a SIM card that is compatible
●
with the chosen mobile network provider, and select a mobile data plan according to the planned level of usage.
The dongle and SIM card enable the remote controller to access specific networks and platforms, such as the DJI
●
AG platform. Make sure to employ them correctly. Otherwise, network access will not be available.
Dongle
* Test procedure: Press the remote controller power button once, then press again and hold to power the remote
controller on. In DJI Agras, tap
the status of all the devices in the network chain are shown in green.
Mounting the RTK Dongle
When using the RTK planning method to plan the operation area, attach the
RTK dongle to the USB-A port on the remote controller.
6
Power Outlet
AC Power Adapter (100 - 240 V)
Remove the dongle compartment cover.
Insert the dongle into the USB port with the SIM card inserted into the dongle,
and test the dongle.*
Reattach the cover firmly.
, and select Network Diagnostics. The dongle and SIM card are functioning properly if
USB Charger
3
2
Battery Release Button