Maintenance And Care; Accessories, Tools; Disposal - Festool PRECISIO CS 50 EB Notice D'utilisation D'origine

8.2 Circular trimming saw
Use the guide as a cross guide or as an angle guide
(Fig. 3) to apply and secure the work-piece. Alter-
natively, clamps (489570) can be inserted in the
grooves [3-8] to secure the workpiece. Perform
the sawing cut by swinging the hand grip [3-9]
downwards and using the hand grip to pull the
saw unit forwards. After making the sawing cut,
move the saw unit right back again into its initial
position before you take the workpiece from the
guide.
9

Maintenance and care

Prior to any setting, maintenance or re-
pair, pull the mains plug!
All maintenance and repair work which
requires the motor casing to be opened
may only be carried out by an authorised
service centre.
Damaged safety devices and parts should
be repaired or replaced by an authorised
service centre unless otherwise specifi ed
in the operating instructions.
Customer service and repair. Only
through manufacturer or service work-
shops: Please fi nd the nearest address
at: www.festool.com/Service
Use only original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/Service
5
3
2
1
The routers are fi tted with special carbon brushes
with automatic-switch-off. When the brushes
reach their wear limit the current is interrupted
automatically and the router comes to a standstill.
Service your machine regularly to ensure that it
functions properly:
- Vacuum off dust deposits
- Keep the guide bars [1-10] clean and grease
them regularly
- A worn or damaged bench insert is to be re-
placed
- The slider [11-1] can be used to open the hatch
[11-3] to enable removal of cutting residues
from the lower protective cover. In order to re-
move larger deposits, the hatch can be opened
completely by removing the screw [11-2]. Prior
to commissioning, the hatch must be closed
again!
- On completion of your work, wind the power
cable around the holders [2-1].
- A damper means that the saw unit runs back
evenly across the entire drawing length. If this
is not the case, the damper can be adjusted
through the hole [2-5].
10

Accessories, tools

Festool offers a comprehensive range of acces-
sories that ensures versatile and effective deploy-
ment of your machine, e.g. table widening, table
lengthening, sliding table, mitre guide, transport
rollers, extraction set.
In order to be able to saw different materials
quickly and cleanly, Festool offers saw blades that
are specially designed for your machine.
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
"www.festool.com".
11

Disposal

Do not throw the power tool in your household
waste! Dispose of machines, accessories and
packaging at an environmentally-responsible re-
cycling centre. Observe the valid national regula-
tions.
EU only: In accordance with European Directive
on waste electrical and electronic equipment
and implementation in national law, used elec-
tric power tools must be collected separately and
handed in for environmentally friendly recycling.
Information on REACh: www.festool.com/reach.
21