Publicité
Les langues disponibles
Les langues disponibles
All work marked with this symbol requires specialist knowledge and technical understanding.
In the interests of your own safety, have these jobs performed by an authorized KTM workshop.
There, your motorcycle will be optimally cared for by specially trained experts using the auxiliary tool required.
Scope of supply
1x top triple clamp
1x bottom triple clamp
1x steering head bearing (preassembled)
1x steering head seal (preassembled)
1x steering stem (preassembled)
8x collar screw M8x40
1x collar screw M10x1.5 (preassembled)
1x collar screw M8x25
Preliminary work
- Raise the motorcycle with a lift stand (see the Owner's Manual).
- Remove the front wheel
- Remove the fork legs
(see the owner's manual).
- Remove the start number plate (see the owner's manual).
- Remove the front fender (see the owner's manual).
- Remove the handlebar pad.
- Remove the lower triple clamp
Preassembly of upper triple clamp
- Remove screws
from the original triple clamp.
- Take off handlebar clamp
triple clamp.
- Remove screws
with lower handlebar mounts
upper handlebar mounts
- Remove rubber bushing
- Mount rubber bushing
on the upper triple clamp
- Mount screws
with upper handlebar supports
handlebar mounts
and tighten to 40 Nm (Loctite 243).
- Position handlebars.
- Mount screws
with handlebar clamp
(tightening torque 60 Nm)
(see the owner's manual).
(see the owner's manual).
and the handlebar from the original
and take off
from the original triple clamp.
from the original triple clamp.
(included).
and lower
and tighten to 20 Nm.
5
Publicité
