Selecting A Location, And Connecting Input Power - Miller Maxstar 150 S Manuel De L'utilisateur

3-7. Selecting A Location, And Connecting Input Power

1
18 in
(460 mm)
Airflow Distance
Requirements
OM-2242 Page 10
18 in (460 mm)
3
2
1 Welding Power Source
Shoulder Strap
Use strap to lift unit.
!
Do not move or operate
unit where it could tip.
!
Installation must meet all
National and Local Codes
− have only qualified
persons
installation.
!
Special installation may be
3
required where gasoline or
volatile liquids are present
− see NEC Article 511 or
CEC Section 20.
.
5
4 The Auto-Line circuitry in this
unit automatically links the
power source to the primary
voltage being applied, either
115 or 230 VAC.
2 Rating Label
Label is located on bottom of unit.
Use rating label to determine
input power needs.
.
CE model rating labels will
also display the following
7
symbols: CE, CCC, WEEE,
6
and IEC 60974-1.
NOTICE − Do Not cut off power
cord connector and rewire. The
power cord connector and plugs
will work with standard NEMA re-
ceptacles. Modifying power cord,
connector, and plugs will void
product warranty.
For 115 volts ac input power, a 15
or 20 ampere individual branch
circuit protected by time-delay
fuses or circuit breaker is
required. For 230 volts ac input
power, see Section 3-5.
3 Power Cord Connector
4 Plug − NEMA Type 5−15P
5 Receptacle − NEMA Type
5−15R (Customer Supplied)
6 Plug − NEMA Type 6−50P
7 Receptacle − NEMA Type
6−50R (Customer Supplied)
Select plug for power supply
receptacle available at site.
Install plug onto power cord
adapter. As threaded collar is
tightened, push plug onto adapt-
er until collar is completely tight.
Connect plug to receptacle.
make this
Ref. 803 351-D / 237 014-A