Selecting A Location And Connecting Input Power - Miller Maxstar 152 Manuel D'utilisation

3-5. Selecting A Location And Connecting Input Power

10 in (254 mm) of
space for airflow
2
Y Do not move or operate unit
where it could tip.
OM-172 200 Page 14
L2
Y Always connect
grounding
1
conductor first.
= GND/PE
3
1 Plate Label
2 Rating Label
Use rating label to determine input
power needs.
3 User-Supplied Plug
Install plug according to manufac-
tures instructions.
4 Receptacle (User-Supplied,
May Vary According To
Location)
Install receptacle according to
manufactures instructions.
5
Connect plug to receptacle.
5 Line Disconnect Device
See Section 3-8.
Y Special installation may be
L1
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
4
L1
L2
230 VAC, 1
input_1 3/96 – Ref. ST-801 504 / Ref. ST-801 603