Working With The Device - Proxxon MICROMOT 230/E Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
5.2 Changing the collets (Fig. 3):
Caution:
Disconnect the mains plug!
1. Press the lock button 1
2. Rotate the spindle with the sleeve nut 2
slightly while pressing the lock button
simultaneously until it engages in the
depression on the spindle.
3. Unscrew the sleeve nut 2
4. Replace the collet 3
5. Screw on the sleeve nut while depressing
the lock button.

5.3 Working with the device

Caution:
Never work without safety glasses.
Do not work with damaged grinding disks
or bent shafts.
Please note:
A correct and uniform speed achieves a high
grinding performance, not excessive contact
pressure.
The following rule of thumb governs selection
of the speed:
Small milling cutters / pins = high speed,
large milling cutters / pins = low speed.
Caution:
Secure the workpiece during work!
In addition to enabling more pleasant and
effi cient working, this also reduces the risk
of the workpiece fl ying about! Please note: A
workpiece fl ying out can cause injuries! Use
a vice or suitable clamping fi xture to hold the
workpiece!
Warning:
It is imperative that electric tool recoil be
avoided!
Factors such as
• the incorrect speed for the work in hand
• selection of the wrong operational tool
- 10 -
• excessive contact pressure
• incorrectly clamped tools
• carelessness during work
can cause the operational tool to seize, catch
and block. The reaction torque may result in an
uncontrolled acceleration of the electric tool or
workpiece in this context which may pose a risk
to the person operating the tool! It is imperative
that this operating condition be avoided. Please
note that operational tools can break, and
their parts fl ying about represent a risk! Risk
of injury!
Selecting the speed:
A correct and uniform speed achieves a high
grinding performance, not excessive contact
pressure.
The following rule of thumb governs selection
of the speed:
Small milling cutters / pins = high speed,
large milling cutters / pins = low speed.
1. Activate the device with the switch 1 (Fig. 1)
and set the right speed for the work on the
knob 2.
2. Fig. 4 illustrates two typical ways of holding
the MICROMOT 230/E. Ensure that you hold
the device fi rmly during work to enable
controlled guiding of the rotating operational
tool. Avoid covering the ventilation slots
during this! In the event of overheating,
deactivate the device and allow to cool for a
few minutes.
5.4 Maintenance, cleaning and care
Caution:
Disconnect the mains plug prior to every
adjustment, maintenance measure or repair!
Note:
Every device is dirtied by dust when working
with wood. Cleaning is therefore essential.
To ensure a long service life, however, the
machine should be cleaned with a soft cloth or
brush after each used.

Publicité

Table des Matières
loading

Table des Matières