Telephone Connection Requirements; Ringer Equivalence Number (Ren); Incidence Of Harm; Changes In Telephone Company Equipment Or Facilities - Johnson Controls tyco 3G4000W Manuel D'utilisation

can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
3G4000W:
FCC ID: F53193G4000W
3G4000W Product Identifier US: F53MO00A3G4000W
US OC Jack: RJ - 31X
WARNING: To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation
distance of 30cm or more must be maintained between the antenna of this device and persons during
device operation.

Telephone connection requirements

A plug and jack used to connect this equipment to the premises wiring and telephone network
must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. See installation instructions for
details.

Ringer Equivalence Number (REN)

The REN is used to determine the number of devices that may be connected to a telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming
call.
In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number
of devices that may be connected to a line, as determined by the total RENs, contact the local
Telephone Company. For products approved after July 23, 2001, the REN for this product is part of
the product identifier that has the format. US: AAAEQ##TXXXX. The digits represented by ## are
the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately
shown on the label.

Incidence of Harm

If this equipment 3G4000W causes harm to the telephone network, the telephone company will
notify you in advance that temporary discontinuance of service may be required. But if advance
notice is not practical, the Telephone Company will notify the customer as soon as possible. Also,
you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

Changes in telephone company equipment or facilities

The Telephone Company may make changes in its facilities, equipment, operations or procedures
that could affect the operation of the equipment. If this happens the Telephone Company will
provide advance notice in order for you to make necessary modifications to maintain uninterrupted
service.

Equipment maintenance facility

If trouble is experienced with this equipment for repair or warranty information, please contact
the facility indicated below. If the equipment is causing harm to the telephone network, the
Telephone Company may request that you disconnect the equipment until the problem is solved.
This equipment is of a type that is not intended to be repaired by the end user.
Tyco Atlanta Distribution Center, 2600 West Pointe Dr., Lithia Springs, GA, 30122 U.S.A.
3G4000W 3G (HSPA) WIRELESS ALARM COMMUNICATOR INSTALLATION MANUAL 5.0 47