Activating A Programmable Output Using The Sms Command And Control Feature; Deactivating A Programmable Output Using The Sms Command And Control Feature; Requesting A Status Request Using The Sms Command And Control Feature - Johnson Controls tyco 3G4000W Manuel D'utilisation

2. Use a mobile phone to send an SMS text message to the panel. Enter disarm and your user
code. For example, disarm 1234.
The 3G4000W communicator responds by sending a message to the end user's mobile phone
that states Function Successful or Function Unsuccessful.
Activating a programmable output using the SMS command
and control feature
About this task:
The 3G4000W supports two outputs that you can connect to the input of many different products.
These outputs can remotely activate a variety of functions, such as a door strike or a light. To acti-
vate a programmable output, complete the followings steps:
1. Ensure that the control panel meets the following conditions:
- The control panel supports a zone input that is programmed as a keyswitch zone type, or
programmed with a similar function.
- The zone input connects to one of the programmable outputs on the 3G4000W.
2. Use a mobile phone to send an SMS text message to the panel. Enter activate, the output
number and your user code. For example, activate 1 1234.
The 3G4000W responds by sending an SMS message to the end user's mobile phone that
states Function Successful or Function Unsuccessful.
Deactivating a programmable output using the SMS
command and control feature
About this task:
To deactive a programmable output, complete the following steps:
1. Ensure that the control panel meets the following conditions:
- The control panel supports a zone input that is programmed as a keyswitch zone type, or
programmed with a similar function.
- The zone input connects to one of the programmable outputs on the 3G4000W.
2. Use a mobile phone to send an SMS text message to the panel. Enter deactivate, the output
number and your user code. For example, deactivate 1 1234.
The 3G4000W responds by sending an SMS message to the end user's mobile phone that
states Function Successful or Function Unsuccessful.
Requesting a status request using the SMS command and
control feature
About this task:
To request a status request, complete the following steps:
3G4000W 3G (HSPA) WIRELESS ALARM COMMUNICATOR INSTALLATION MANUAL 5.0 21