Nameplate; Maintenance And Care - Sopur Easy Life RT Notice D'utilisation

8.0 Nameplate

Name Plate
The nameplate is located on either the cross-tube assembly or
the transverse frame tube, as well as on a label in the owner's
manual. The nameplate indicates the exact model designation
and other technical specifications. Please provide the following
pieces of information whenever you have to order replacement
parts or to file a claim:
• Serial number
• Order number
• Month/Year
SAMPLE
Sunrise Medical GmbH
Kahlbachring 2-4
D-69254 Malsch / Germany
Rollstuhl
TYPE:
Easy Life RT
100 kg max 10° 440 mm
Easy Life RT
Product Name/SKU Number.
Maximum safe slope with anti-tip tubes
fitted, Depends on wheelchair setting,
posture and physical capabilities of the user.
max X°
Seat width.
XXX mm
Seat depth.
XXX mm
Load Maximum.
kg
XXX kg
CE Mark.
User's Guide.
XXXX-XX-XX
Date of manufacture.
Serial number.
This symbol means Medical Device.
Manufacturer's address.
Crash tested according to
ISO 7176-19:2008
ISO 7176-19:2008.
Sopur Easy Life RT Rev.H
2021-04-09
203211232764724
340 mm

9.0 Maintenance and care

• Check the tyre pressure every 4 weeks. Check all tyres for
wear and damage.
• Check the brakes approximately every 4 weeks to make
sure that they are working properly and are easy to use.
• Change tyres as you would an ordinary bicycle tyre.
• All of the joints that are critical to using your wheelchair
safely are self-locking nuts. Please check every three
months to make sure that all bolts are secure (see the
section on torque). Safety nuts should only be used once
and should be replaced after use.
• Please use only mild household cleansers when your
wheelchair is dirty. Use only soap and water when cleaning
the seat upholstery.
• You should only use genuine parts approved by Sunrise
Medical. Do not use parts from other manufacturers, that
have not been by authorised by Sunrise Medical.
• If your wheelchair should ever get wet, please dry it
afterwards.
• A small amount of sewing-machine oil should be applied to
quick-release axles approximately every 8 weeks.
Depending on the frequency and type of use, we
recommend taking your wheelchair to your authorised
dealer every 6 months to have it inspected by trained
personnel.
• If you want to store the wheelchair for a long period of time,
then no further measures are required. Make sure that the
wheelchair is stored at room temperature in a dry place
which is protected from strong sunlight. Before using it
again, the wheelchair should be checked by an authorised
dealer.
CAUTION!
Sand and sea water (or salt in the winter) can damage the
bearings of the front and rear wheels. Clean the wheelchair
thoroughly after exposure.
The following parts can be removed and sent back to the
manufacturer/dealer for repair:
• Rear wheels
• Armrest
• Anti-Tip tubes
These components are available as spare parts. For
further information, please see the spare parts catalogue.
Hygiene measures when being re-used:
Prior to the wheelchair being re-used, it must be carefully
prepared. All surfaces which come into contact with the user
must be treated with a disinfection spray.
To do this, you must use a disinfectant from the DGHM list, e.g.
Antifect Liquid (Schülke & Mayr) for rapid alcohol-based
disinfection for medical products and medical devices, which
must be disinfected quickly.
Please pay attention to the manufacturer's instructions of the
disinfectant you are using.
In general, a complete disinfection cannot be guaranteed on
seams. We therefore recommend that you dispose of seat and
back slings to avoid microbacterial contamination with active
agents according to § 6 infection protection law.
51