Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance and care
A regular inspection and maintenance of your machine will help to prevent
faults. This saves time and prevents problems.
Overall condition of the machine
Check spray arm for grease and limescale deposits. If you ind deposits do the
following:
•
Fill detergent dispenser with detergent.
•
Start the appliance without utensils in the cycle with the highest rinsing
temperature.
•
Clean the appliance with detergents/appliance cleaners which are suitable
for use with dishwashers.
•
Regularly clean door seal with a damp cloth.
Never use a steam cleaner to clean your dishwasher. The manufacturer is not
liable for any consequential damage.
Regularly wipe the front of the appliance and fascia with a damp cloth; water
and a little liquid soap are adequate.
Do not use sponges with a rough surface or abrasive detergents, as these
could scratch the surfaces.
Stainless steel appliances
To prevent corrosion, avoid using sponge cloths.
Filters
The ilter system consists of a coarse ilter, a lat ine ilter and a micro ilter.
The ilters keep large foreign objects in the rinsing water away from the pump.
These foreign objects may occasionally block the ilters.
Check the ilters for residue by:
•
Unscrew ilter cylinder as illustrated and take out ilter system.
•
Remove any residue and clean ilters under running water.
Reinstall ilter system in reverse sequence and ensure that the arrow marks are
opposite each other after closing the ilter system.
Spray arms
Limescale and contaminants in the rinsing water may block nozzles and
bearings on the spray arms.
Check outlet nozzles on the spray arms for blockages by:
•
Unscrew the upper spray arm.
•
Remove the lower spray arm.
Waste water pump
Large food remnants in the rinsing water not retained by the ilters may block
the waste water pump. The rinsing water does not get pumped out and covers
the ilter. In this case:
•
Disconnect the appliance from the power supply.
•
Remove the ilters.
•
Scoop out water, use a sponge if required.
•
Using a spoon, pry of pump cover (as illustrated) until it clicks, then grip
the cover by the lug and irst pull it upward until it resists and then pull it
out forward.
•
Check inner compartment and remove any foreign objects.
•
Place cover in the original position, press down and engage.
•
Install ilters.
19
1
2
1
3
2
Click
Klick
Publicité
Chapitres
Table des Matières
