Rack Accessories - Thermador DWHD650G Série Instructions D'installation

Rack accessories

Flip tines *
Flip tines fold down to make loading the racks easier in some instances. Grasp the
tines, release from notch, and fold the tines downward. When the top rack is loaded,
push it into the dishwasher.
Extra-Tall-Item™ Sprinkler *
If an item is too tall to be placed into the bottom rack even with the top rack in the
raised position, remove the empty top rack by pulling it out of the dishwasher until
it stops rolling. Pull the front of the rack upward and outward until the rollers are
completely free of the roller guides. Set the top rack aside. Push the roller guides
back into the dishwasher.
Insert the Extra-Tall-Item™ Sprinkler into the top rack spray outlet and turn the
sprinkler clockwise to lock it into position as shown above. Place your extra tall
item(s) in the bottom rack as shown above.
NOTE: Keep the vent on the tub's right side clear by placing tall items such as plastic cut-
ting boards and tall baking sheets on the left side, center, or back of the bottom rack.
Plastic item clips *
Light-weight plastic accessories (e.g. cups, lids) can be held securely by the plastic
item clips.
3-Step Rackmatic
®
Adjusting the height of the rack
The height of the upper rack can be adjusted in 3 steps to create more space.
• Pull out the top rack.
• To lower the rack, push the lever inwards then upwards.
• To raise the rack, hold the basket on the sides of the upper edge and lift it up.
Before re-inserting the rack, ensure that it is at the same height on both sides.
Otherwise, the appliance door cannot be closed and the upper spray arm will not be
connected to the water circuit.
*model dependent
1
2
12