Initial Setting - SOMFY Soliris io Notice

EN

Initial setting

Set the Wind potentiometer (M) to the threshold adapted to the type of motorised product according to
the table of thresholds.
After about 2 s, the Wind LED flashes a certain number of times indicating the threshold level set.
Adjusting the threshold
The sensitivity threshold setting can be changed according to the actual weather conditions and
requirements.
1] Turn the potentiometer to the right or left until the Wind LED (K)
is permanently lit green :
The wind sensor's sensitivity threshold is set according to the
current wind value.
͉
͉
Note :
- Wind LED off: the sensitivity threshold set has not been reached, the wind is blowing below the set
threshold: the motorised product does not move.
- Wind LED permanently lit green: the sensitivity threshold set has been reached, the wind is blowing above
the set threshold: the motorised product moves to the safety position.
2] Check that the motorised product reacts automatically when
the wind blows stronger than the threshold set and that, in these
conditions, the motorised product is not damaged.
If the motorised product does not react as desired, adjust the sensitivity threshold :
• Turn the potentiometer towards the (+) sign to increase the sensitivity threshold: a stronger wind
causes the motorised product to be moved to the safety position.
• Turn the potentiometer towards the (-) sign to decrease the sensitivity threshold: a weaker wind
causes the motorised product to be moved to the safety position.
2.5.4. Setting the sun sensitivity threshold
The sensitivity threshold setting can be changed according to the actual weather conditions and
requirements.
Turn the Sun potentiometer until the Sun LED (J) is permanently lit green :
The sun sensor's sensitivity threshold is set according to the current level of sunshine.
͉
͉
Note :
- Sun LED off: the sensitivity threshold set has not been reached, the sun is shining below the set threshold:
the motorised product does not move.
- Sun LED permanently lit green: the sensitivity threshold set has been reached, the sun is shining above the
set threshold: the motorised product is lowered automatically after a few minutes.
Table of thresholds
͉
͉
Values are accurate to within ± 3.5 kilolux. The position of the sensor on the location influences the detection.
Thresholds
klx
Number of flashes
To adjust the sensitivity threshold :
• Turn the potentiometer towards the (+) sign to increase the sensitivity threshold: the sun must shine
more brightly to cause the motorized product to lower.
• Turn the potentiometer towards the (-) sign to decrease the sensitivity threshold: the sun must shine
less brightly to cause the motorized product to lower.
22
1 2
≈ 1 ≈ 8,3
★ ★ ★
Copyright
3 4
≈ 16,7 ≈ 25
★ ★ ★ ★ ★ ★ ★
© 2019-2020 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
1]
2]
5 6
≈ 33,3 ≈ 41,7
★ ★ ★ ★
★ ★ ★ ★ ★
★ ★
Soliris io
7
≈ 50
★ ★ ★ ★ ★
★ ★