Table des Matières
Publicité
26 | Troubleshooting
SYMPTOM
POSSIBLE CAUSES
Table Mic
Table Microphone
Mode:
may be too far from
Difficult to
speaker.
hear speaker
in noisy
environments.
Remote
Table Microphone
Mic Mode:
may be covered by
Difficult to
clothing or poorly
hear speaker
positioned.
in noisy
environments.
No streamed
Hearing aids are not
sounds are
paired with Table
heard in the
Microphone.
hearing aids.
No incoming audio
signal is available.
Device is not
Possible error
responding.
condition.
SOLUTIONS
Move Table Microphone
closer to speaker's mouth.
Provide clear access from
Table Microphone to
speaker's voice.
Follow steps in Pairing
section.
• Turn on the electronic
audio source.
• Unmute or increase
volume on electronic
audio source.
Press power button for 8
seconds to force shutdown.
Turn on as usual.
Safety Information
Required Information
Waste from electronic equipment must be handled according
to local regulations.
Instructions for Disposal of Old Electronics
Starkey Hearing Technologies encourages, and your local community laws may
require, that your Table Microphone be disposed of via your local electronics
recycling/disposal process.
The below instructions are provided for the benefit of disposal/recycling
personnel. Please include this manual when disposing of your Table Microphone.
For Disposal/Recycling Personnel Only
This product contains a Lithium Ion Polymer battery. To remove this battery:
• Power off the Table Microphone.
• Pry apart the housing halves with a small screwdriver.
• Cut the battery wires from the circuit board to prevent accidental shorting.
• Pry the battery away from the housing using a wide flat blade.
Intended Use
The Table Microphone is an assistive listening device which transmits sound via wired
earphones or to a 2.4 GHz wireless air conduction hearing aids. When worn by a
distant speaker or used in noisy environments, it functions as a Remote Microphone.
It also functions as a TV Streamer when connected to the TV's audio output.
The Table Microphone is designed to comply with Standards of International
Electromagnetic Compatibility. However, it is still possible that you may
experience interference caused by power line disturbances, airport metal detectors,
electromagnetic fields from other medical devices, radio signals and electrostatic
discharges.
The Table Microphone is designed to be cleaned with a damp cloth moistened with
soapy water.
Safety Information | 27
Publicité
Table des Matières
