Security Functions; Resetting The Factory Codes - Conrad Electronic 75 15 16 Notice D'emploi

I) Operating output 1:
Enter the programming code —- "#" —- "1" (manual code input).
Enter the programming code —- "1" (automatic code input)
II) Operating output 2:
Enter the programming code —- "#" —- "2" (manual code input)
Enter the programming code —- "2" (automatic code input)

Security functions

(1) After 3 to 10 wrong entries (can be defined at wish), the system blocks
automatically or triggers the alarm.
(2) If the door is forced open, the system triggers the alarm immediately.
(3) If the door is left open longer than defined in the default settings for the door opening
times, the alarm sounds to remind you to close the door.
(4) If the tamper switch is activated, the system emits the following warning signals:
The yellow LED blinks and the buzzer sounds continuously. By deactivating the tamper
switch, the acoustic and optical warning signals are stopped. The tamper switch can
also be connected to a security system.

Resetting the factory codes

Did you forget the master code or programming code and want to change it? Use the
DAP jumper (see connection, point a)!) to restore the factory code 1234.
For this purpose, proceed as follows:
(1) Disconnect the voltage supply.
(2) Plug the DAP jumper to position "ON".
(3) Restore the voltage supply. Now the yellow LED blinks continuously and the buzzer
also sounds continuously.
44