Programming; Programming The Master Code (Programming Code) - Conrad Electronic 75 15 16 Notice D'emploi

Programming

Prior to commissioning your new code lock, you first have to program it and change the
factory code.
- The default factory code is: 1 2
- Calling up the programming mode: Input: " " —- "Master code" —- "#"
- Exiting the programming mode:
Successful programming:
yellow LED (4) blinks 2 x and the buzzer sounds 2 x
Wrong programming:
yellow LED (4) blinks 5 x and the buzzer sounds 5 x

(1) Programming the master code (programming code)

You need the master code (previously factory code) to access the programming
mode. You always have to enter this code once you have quit the programming
mode to e.g. establish new ID cards or user codes or make other modifications to the
individual settings.
The user numbers / user ID cards / user codes may not be assigned twice.
The system does not accept double assignments and the following display
appears: yellow LED (4) blinks 5 x and the buzzer sounds 5 x.
If previously saved data is deleted, a new user can be saved using the old
number.
In case of a wrong entry, press the button "#" or wait 10 seconds to make
the new entry!
If no other button is pressed within the next 10 seconds, the code
lock automatically returns to standby mode. Therefore, make all the
following entries as fast as possible.
36
3 4
(yellow LED (4) and green LED (5) lit)
Input: Press button " " once
(yellow LED (4) blinks in 2-second intervals)