Saving Id Cards Or User Codes (Output 1); Saving Id Cards - Conrad Electronic 75 15 16 Notice D'emploi

Press the "asterisk" button " " on the keypad (6). Now enter the
factory code 1234 and confirm this with the "number" key "#". The yellow (4) and the
green (5) LED light up and you are in programming mode.
Now press the key "0" on the keypad (6) and enter a new programming code (mas-
ter code, at least 4 digits, at most 8 digits). Then confirm the programming of the
code with the "number" key "#" on the keypad (6).
Input: " —- "1" —- "2" —- "3" —- "4" —- "#" —-
"master code" —- "#"
(2) Saving ID cards and user codes (output 1)
Please note that the following chapters only refer to saving ID cards and user codes
for output 1!
Before saving ID Cards or User Codes, you first must assign a 4-digit User Number
for the ID Cards or User Codes (password).
Successful operation: yellow LED (4) blinks 2 x and the buzzer sounds 2 x as well
A. Saving ID cards
On the keypad (6) press the key "1" and now enter a 4-digit User Number of your
choice. Then teach in the user ID card and press the "number" key "#" on the key-
pad (6).
Input: "1" —- "4-digit User Number" —- "ID card" —- "#"
If you want to save several ID cards, you do not have to press the
"number" key "#" after each individual card. Save the individual cards
as described above and press the "number" key "#" after the last card.
This saves all previous cards as well.
For security reasons, you should not pass this master
code on to third parties, as this serves as authorisation
for programming and deleting the ID cards and user
codes.
"0" —-
37