Saving Of User Codes (Output 2); Deleting User Codes (Output 2); Programming The Opening Times (Output 2) - Conrad Electronic 75 15 16 Notice D'emploi

B. Press the buttons "4" —- "1" —- "#"
Output 1: is locked
(6) Saving of user codes 2 (output 2)
Please note that the following chapters only refer to saving "user
number" with "user code" for output 2!
Enter any 3-digit numerical combination for each user code - this may not be repea-
ted during programming, however!
Press the keys "5" —- "1" —- "3-digit user number" —- "4 to 8-digit user code" —- "#"
(green LED (5) blinks) —- "#" (green LED (5) no longer blinks). Input is completed.
Red LED (2) is lit as long as output 2 is active.

(7) Deleting user codes (output 2)

A: Press the buttons "5" —- "0"—- "0" —- "0" —- "0" —- "#"
This deletes all user codes.
B. Press the
—- "#". Now the entered user code is deleted.
C. Press the keys "5" —- "3" —- enter the "user number" of the user code —- "#".
Now the additional user code with the respective user number is deleted.
(8) Programming the opening time (output 2)
A. Press the keys "6" —- "0" —- ("01" – "99" seconds) —- "#"
Output 2: Relay opens between 1 and 99 seconds.
Factory setting = short-time mode: 3 seconds!
If you want to save several user codes, you do not have to press the
"number" key "#" after each individual entry. Save the individual entries
as described above and press the "number" key "#" after the last entry.
This saves all previous entries as well.
keys "5" —- "2" —- "user code" to be deleted
39