Programming The Security Functions (For Output 1 Only) - Conrad Electronic 75 15 16 Notice D'emploi

D. Burglary alarm (magnetic contact required - for output 1 only)
I) Press the buttons "7" —- "3" —- "0" —- "#"
The alarm is deactivated.
II) Press the buttons "7" —- "3" —- "1" —- "#"
The alarm is triggered in case of burglary.
If a magnetic contact is connected, the function must be activated
.
E. Programming the alarm time (clamp ALMOUT)
Press the keys "7" —- "4" —- ("01" – "99" minutes) —- "#"
Now you can define the duration of the alarm (01 to 99 minutes)

(10) Programming the security functions (for output 1 only)

A. Press the buttons "8" —- "0" —- "0" —- "#"
The security functions are inactive.
B. Press the buttons "8" —- "0" —- "1" —- "#"
Alarm display - ALM OUT after 10 invalid ID cards or 10 wrong codes or 1 valid
ID card and 5 wrong user numbers inputs.
The alarm can be turned off by reading a valid user ID card or entering the cor-
responding user code or the user ID card plus user code.
C. Press the keys "8" —- "1" —- (03 - 10 inputs) —- " "
minutes) —- "#". With this setting, you can define when the system is to be blocked
If you enter the digit "03", the system is blocked after the 3rd invalid ID card or
wrong codes. If you enter the digit "04", after the 4th wrong entry, etc.
Either 3 -10 invalid ID cards or 3-10 wrong codes or 1 valid
ID card + 5 wrong user numbers.
Factory setting = alarm signal is deactivated!
Factory setting = alarm time: 1 minute
—- (01-99
41