Pin Assignment - Conrad Electronic 75 15 16 Notice D'emploi

Pin assignment

a) DAP tamper For resetting the factory code.
b) TAMPER (sabotage contact)
Is triggered as soon as the housing cover is opened.
c) TAMPER BEEP
Set this to "ON" - internal buzzer will sound if the cover is opened.
Set this to "OFF" - internal buzzer will be disabled.
d) TAMPER H NC. L (NC contact)
Tamper output for connecting to external alarm system.
e) DOOR SENS / GND / KEY ACT
- Connection magnetic contact
- Connection external siren (piezo), or light, or relay.
f) ALMOUT / N.O. EG
- Connection of a siren or revolving light. (Ground contact)
- Connection of Egress Button
g) Connection "12V DC IN + -"
Connection of the supply voltage
h) DOOR BELL
Connection of a door bell
i) EXT. CARD READER
Connection of an external card reader. (Please observe the operating instructions of
the card reader!)
j) OUTPUT 2 = Output 2
Output 2 (connection of an automatic door opener)
k) OUTPUT 1 = Output 1
Output 1 (connection of an automatic door opener)
34