Completing The Programming; Operating The Code Lock - Conrad Electronic 75 15 16 Notice D'emploi

Example 2: The door was forced open - the buzzer sounds as alarm signal - the alarm
persists even if the door is closed now. The alarm can only be deactivated
when entering a valid ID card, a user code or the combination of ID card and
user number.
(12) Completing programming
You exit the programming mode automatically after 60 seconds.
However, always press the key " " to exit the programming mode and return to ope-
rating mode! Now the system is in standby and the yellow LED (4) blinks.

Operating the code lock

(1) Output 1:
I) Open the door via ID card (introducing the ID card)
II) Open the door with the user code (enter the user code)
III) Open the door by introducing the ID card and entering the user number.
(Introduce the ID card, the green LED blinks - now you have to enter the user
number within 10 seconds.)
(2) Output 2:
In this case, operation takes place with the user code. Output 2 is activated by
entering the user code.
Output 1 and 2 can be operated in any case with the programming code! Pro-
ceed as follows:
The yellow LED (4) blinks in 2-second intervals and the system is rea-
dy for operation!
While the green LED (5) blinks, you can also return to normal opera-
ting mode / standby mode by pressing the key " ".
43