Faro MC01 RL Mode D'emploi page 46

Contre-angle
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MC01 R / RL - Instructions for use - EN
5.3 Inserting the milling tool or diamond grinder
NOTE
Only use carbide cutters or diamond grinders that comply with ISO 1797-1 type 3, are made of steel or hard metal and meet the following criteria:
- Shaft diameter: 1.59 to 1.60 mm
- Overall length: max. 25 mm
- Shaft clamping length: min. 11 mm
- Blade diameter: max. 2 mm.
WARNING
Use of unauthorised cutters or grinders.
Injury to the patient or damage to the medical device.
 Observe the instructions for use and use the cutter or grinder properly.
 Only use cutters or grinders that do not deviate from the specified data.
CAUTION
Injury from using worn cutters or grinders.
Cutters or grinders could fall out during treatment and injure the patient.
 Never use cutters or grinders with worn shafts
44

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mc01 r

Table des Matières