Vent Shield Installation - Napoleon Acies Série Manuel D'installation

5.6

vent shield installation

note:
The vent shield is telescopic and must be adjusted to shield at least the first 15" of vertical vent always used.
1. Unscrew the fasteners on the vent shield assembly. DO NOT DISCARD FASTENERS (Figure 1).
2. Adjust vent shield to its a minimum of 15" (Figure 2).
3. Use the fasteners in step 1 to hold the new vent shield height (Figure 3).
4. Unscrew the fasteners as shown in Figure 4. DO NOT DISCARD FASTENERS
5. Use the fasteners in step 4 to secure the vent shield to the appliance (Figure 5).
6. Secure the vent shield with two fasteners (supplied) to the front upper frame (Figure 6).
FOR SEE-THRU APPLIANCES, REPEAT STEPS WITH THE OPPOSITE SIDE. (Two vent shields required)
Fig. 1
Fig. 4
venting installation
Fig. 2
Type 1 (x2)
Fig. 5
SEE-THRU EXAMPLE
EN
Fig. 3
Fig. 6
33
W415-1707 / 07.04.17