Glass / Door Replacement; Care Of Glass; Care Of Plated Parts - Napoleon Acies Série Manuel D'installation

13.6 glass / door replacement

WARNING
!
• Do not use substitute materials.
• Glass may be hot. Do not touch glass until cooled.
• Care must be taken when removing and disposing of any broken door glass or damaged components. Be
sure to vacuum up any broken glass from inside appliance before operation.
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, broken, or scratched.
Replacement glass/frame assembly shall be replaced as a complete unit as supplied by the appliance
manufacturer.

13.7 care of glass

WARNING
!
• Do not clean glass when hot! Do not use abrasive cleaners to clean glass.
Buff lightly with a clean dry soft cloth to remove accumulated dust or fi ngerprints. Clean both sides of the glass
after the fi rst 10 hours of operation with a recommended fi replace glass cleaner.
4
note:
note:
Vinegar-based or ammonia-free glass cleaners have generally demonstrated an ability to provide a clean,
Glass cleaners with ammonia will discolour the glass. Do not use ammonia based cleaners.
streak free glass surface.
Thereafter clean as required. If the glass is not kept clean permanent discoloration and / or blemishes may
result. Contact you local authorized dealer / distributor for complete cleaning instructions.
Do not contact the inside surface of the glass with razor blades, steel wool or other metallic objects as a thin
layer of metal removed from the object may be deposited onto the coating which results in a discoloured stain
or scratch like mark. More importantly, this can scratch the glass surface thereby reducing its strength.
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
If the glass should ever crack or break while the fi re is burning, do not open the door until the fi re is out. Do not
operate the appliance until the glass has been replaced. Contact you local authorized dealer / distributor for
replacement parts. DO NOT SUBSTITUTE MATERIALS.

13.8 care of plated parts

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated surfaces
before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean. If not cleaned
properly before operating for the fi rst time, the marks can cause permanent blemishes on the plating. After the
plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance is required, just wipe clean
as needed. Prolonged high temperature burning with the door ajar may cause discolouration on plated parts.
note:
The protective wrap on plated parts is best removed when the assembly is at room temperature but this can
be improved if the assembly is warmed, using a hair dryer or a similar heat source.
This appliance is factory equipped with 4mm tempered glass. Use only replacement parts as supplied by the
appliance manufacturer. DO NOT SUBSTITUTE MATERIALS
maintenance
38.1
5.1
6.1
W415-1707 / 07.04.17
EN
59