Mobile Home Installation; Hardware List; Lifting Handles Installation/Removal - Napoleon Acies Série Manuel D'installation

general information
EN
1.4

mobile home installation

This appliance must be installed in accordance with the manufacturer's instructions and the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States or the Mobile Home
Standard, CAN/CSA Z240 MH Series, in Canada. This appliance is only for use with the type(s) of gas
indicated on the rating plate.
This mobile/manufactured home listed appliance comes factory equipped with a means to secure the appliance. The
shipping brackets that secure the appliance to the pallet can be used to secure the appliance to the floor for mobile
home installation. For mobile home installations, the appliance must be secured.
This appliance is certified to be installed in an aftermarket permanently located, manufactured (mobile) home,
where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible
for use with other gases, unless a certified kit is used.
Conversion Kits
This appliance is field convertible between Natural Gas (NG) and Propane (P).
To convert from one gas to another, consult your Authorized dealer/distributor.
1.5

hardware list

1
1.6

lifting handles installation/removal

Secure the lifting handles to the side of the appliance
as shown with the screws supplied. Once the
appliance is in place remove the four screws each
handle to the appliance. Discard the lifting handles.
note:
The lifting handles MUST be removed prior to rough
framing the appliance.
10
W415-1707 / 07.04.17
Description
1 Hex Head Sheet Metal Screw
Round Head Sheet Metal Screw
2
3 Hex Head Sheet Metal Bolt
note:
Only fasteners supplied with the appliance are illustrated.
2
Type 1 (x4)
3
Quantity
L38 L50
22 22
4 4
18 18