Vent Shield Installation - Napoleon Vector Serie Manuel D'installation

Masquer les pouces Voir aussi pour Vector Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

venting installation
EN
5.6

vent shield installation

note:
The vent shield is telescopic and must be adjusted to shield the first 30" of vertical vent always used.
1. Unscrew the fasteners on the vent shield assembly. DO NOT DISCARD FASTENERS (Figure 1).
2. Adjust vent shield to its maximum vertical (Figure 2).
3. Use the fasteners in step 1 to hold the new vent shield height (Figure 3).
4. Unscrew the fasteners as shown in Figure 4. DO NOT DISCARD FASTENERS
5. Use the fasteners in step 4 to secure the vent shield to the appliance (Figure 5).
6. Secure the vent shield with two fasteners (supplied) to the front upper frame (Figure 6).
FOR SEE-THRU APPLIANCES, REPEAT STEPS WITH THE OPPOSITE SIDE (2 vent shields required).
32
W415-1709 / A / 07.27.17
Fig. 1
Fig. 4
Fig. 2
Type 1 (x2)
Fig. 5
SEE-THRU EXAMPLE

Publicité

Chapitres

Table des Matières
loading

Table des Matières