ST Quadrat LUX-top RVT Manuel D'utilisation page 20

Masquer les pouces Voir aussi pour LUX-top RVT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation spacings:
The distances from the edge are to be chosen in accordance with the national provisions
and depending on the roof geometry.
The correct choice and layout of anchor devices provided permanently on the roof must be
made depending on the type and use of the anchor device and taking into account the
special features of the roof.
Information on the recommended type and positioning of anchor points is provided, for
example, in BGI 5164
(Planning principles for anchor devices on roofs), which were drawn up and agreed by the
international expert work group D-A-CH-S.
The brochure is available, among other things, under
and can be downloaded free of charge.
National provisions are not affected by these recommendations. Where these suggestions
differ from national law, the user of these recommendations bears the full legal risk to the
scope of the deviation.
Allowable distances between anchor points in the
As pure, individual anchor points
With temporary horizontal anchor devices
®
With
LUX-top
FSE 2003
If you are at all uncertain, please contact the manufacturer
*Results from the edge fall problem of connectors for horizontal use.
Directly at the fall edge, work to the side of the anchor point should be limited to max. 1.5 m distance from the anchor point!
Combination with other LUX-top
®
The
LUX-top
RVT
and as an intermediate point (optionally also with traversable rope guide (anchor line))
®
the
LUX-top
FSE 2003
also note and follow the user instructions of the
®
The
LUX-top
RVT
temporary horizontal flexible anchor lines to EN 795 Type C. In this case, note and
follow the user instructions of the respective temporary system!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.lux-top-absturzsicherungen.de
"Planungsgrundlagen von Anschlageinrichtungen auf Dächern"
stainless steel rope systems
®
products:
product can be used as an extremity (start or end) or corner point
stainless steel rope system to EN 795 Type C. In this case,
product can be used with temporary horizontal anchor devices /
page 5
www.lux-top-absturzsicherungen.de
®
LUX-top
RVT
Maximum 3.0 m*
Maximum 7.5 m
Larger distances are possible depending on the system
Maximum 7,5 m (recommended)
Maximum 15 m (in accordance with test certificate)
®
LUX-top
FSE 2003
version 04/2018
system
in
system!

Publicité

Table des Matières
loading

Table des Matières