Mettler Toledo 11131651 Notice De Montage page 3

Cleaning the draft shield
English
To thoroughly clean the draft shield glasses, remove the draft shield.
On no account use cleaning agents, which contain solvents or abrasive ingredients.
When reinserting the glass, ensure that it is in the correct position.
A
B
B
Remove the following parts:
– Weighing pan, draft-shield element (0.1 mg
models), pan support (1 mg models).
– Lift the draft shield off the balance and
place it on a clean surface.
– Remove the bottom plate.
– Push all the glasses back as far as they will
go.
– Turn the cover (A) to the front.
– Pull the top glass toward the back and off.
– Pull the side glasses toward the back and
off.
Note: Always hold the 2 parallel
guided glasses (side glasses and
top glasses) together with one
hand (illustrations below).
– Clean all parts then reassemble the draft
shield in the reverse order.
Insert glasses:
Note: Always hold the 2 parallel
guided glasses (side glasses and
top glasses) together and paral-
lel with one hand (illustrations
below). The side glasses must
not be placed oustside the projec-
tions (B).