Mettler Toledo 11131651 Notice De Montage page 2

Draft shield for XP/XS precision balances
English
Unpacking the draft shield
B
D
Installing the draft shield and weighing pan
Place the following components on the balance in the specified order:
Note: Push the side glass back as far as it will go and grasp the draft shield with both hands on the bars at the top.
XP precision balances with readability of 0.1 mg
1
– Place the draft shield on a clean surface.
A
– Turn so the cover (A) is vertically on top.
– Lift the carton (B) off over the handle and the pull the carton off toward the back.
– Close the cover (A) again.
– Push all the glass panels as far as they will go to the back.
XP precision balance with 0.1 mg redability
– Place the ring seal (C) into the draft shield base (D) from above.
• Push the complete ring seal (C) through the opening in the draft shield base
D
E
C
– Insert the bottom plate (E).
C
XP/XS precision balances with 1 mg readability
– Insert the bottom plate (E).
– Draft shield (1) with
ring seal inserted
4
– Bottom plate (2), if
not already inserted
3
– Draft shield element
(3)
– Weighing pan (4)
2
Note: Hold the glass panels firmly so they do not get pulled off and fall
to the floor!
and then pull the top edge upward through the opening untnil the edge lies
flat and tight all the way round.
Note: Check by running a finger all the way round that the seal ring (C)
is fitted tightly into the opening in the draft shield base (D), see
illustration.
XP/XS precision balances with readability of 1 mg
1
– Draft shield (1)
4
– Bottom plate (2), if
not already inserted
– Pan support (3)
– Weighing pan (4)
3
2