Make sure the small hole at the mounting
side of the accessory matches the locat-
ing pin of the accessory holder. Never
insert the accessory upside down.
3.
Tighten the locking screw (4) clockwise to
fasten the accessory. Make sure the
accessory clamp is firmly secured!
Carefully pull the accessory to make sure
the accessory is firmly secured.
4.
Reinsert the battery into the tool.
ACCESSORIES
Saw blades:
Saw blade for wood:
Saw blade for metal:
When cutting metals, lubricate saw blade
regularly with oil
Saw blade for wood/ pruning:
Scrapers:
Material: timber products, plastics, varnish and
coatings, remaining adhesive
Purpose: scraping and cleaning surfaces,
removing remaining adhesives and coatings
Sanding pad:
Material: varnish and coatings, plastics, metals
Purpose: sanding work
7062250_18V_repsaw-Ma-#1505-01.indb 17
Abrasive Scouring pad:
Material: Metals
Purpose: removing dust and rust, polishing,
sanding
Steel Wire brush:
Material: Steel
Purpose: removing rust and persistent dirt
Nylon wire brush:
Material: Metals, wood, plastic
Purpose: Removing persistent dirt
OPERATING
1.
Fasten the work piece in a suitable vice
before cutting. If possible, remove any
foreign bodies such as nails, screws etc.
or make sure not to cut the foreign bodies
with a saw blade that is not suitable for
this work.
2.
Insert the battery into the battery slot of
the tool. Always hold the reciprocating
saw firmly with both hands on both insu-
lated handles (6) and (8). Never reach over
the accessory clamp or the foot plate.
There is danger of injury!
3.
To switch ON the reciprocating saw,
press and hold the lock-off button (3) and
then operate the on/off trigger (7). Press in
the on/off trigger further in to increase the
stroke rate. For a lower stroke rate only
slightly impress the on/off trigger. The
stroke rate can be adjusted during
operation.
4.
Do not start cutting, if the saw blade is
inside the work piece or contacts the
surface of an object. There is danger of
serious injury or damages.
.
English
17
22-05-15 13:36