Kemper Clean Air Tower Mode D'emploi page 70

The time until the dust collection container must be exchanged depends on the type
and quantity of the attacking dust. The operator must check the level by hand at
regular intervals to avoid the dust collection container becoming overfull.
The dust collection container must always be exchanged in good time to avoid
contamination of the surroundings!
The filter system should be switched off when checking the fill level. Activate the
On/Off switch and wait until the light ring on the on/off switch completely stops
blinking. Then pull out the mains plug.
Afterwards, do the following:
• Lift the dust collector container (pos. 1) a bit (A), until it releases from the magnet
holder (pos. 2).
• Pull out the underside of the dust collector container (pos. 1) far enough (B), so that
at the magnet holder (pos. 2) it can be pulled down (C). The remove it by pushing it
back (D).
• Close the opening to the dust collection container (pos. 3) using the attached sticker
(pos. 4) which is located in the dust collection container.
• Insert a new dust collection container in reverse order. Please ensure that the seal
(pos. 3) on the dust collection container (pos. 1) is not damaged and that the dust
collection container (pos. 1) is noticeably held by the magnet holder (pos. 2).
Part no.: 150 2627 (CAT 2.0)
All rights over changes without prior notice and errors reserved.
KEMPER CleanAirTower 2.0 Operating instructions - EN
Figure 11, changing the dust collection
container
- 70 - Rev.: 00
Issue: 02/2017