Kemper Clean Air Tower Mode D'emploi page 62

Connect the dust chute pipe (item 1) with the filler pipe (item 3) with the hose
●
NW60 (item 2) and secure them with jubilee clips.
Connect the plug (M12) for the three solenoid leads on the sockets (items 1, 2
●
and 3) of the connection block. The sequence does not matter here.
Connect the motor vibrator plug with the 4-pin socket (item 4).
●
Connect the earth lead to the bolt M4 (item 5).
●
Figure 6, Solenoid lead and motor vibrator lead connection block
• Connect the compressed air supply line (blue, D=8mm) to the plug connection
(item A).
• Connect the drainage line (white/natural color, D=8mm) to the plug connection
(item B).
• Connect the differential pressure line (transparent, D=6mm) with the plug
nipple on the hose (item C).
Part no.: 150 2627 (CAT 2.0)
All rights over changes without prior notice and errors reserved.
KEMPER CleanAirTower 2.0 Operating instructions - EN
- 62 - Rev.: 00
Issue: 02/2017