Operating Elements - Kemper Clean Air Tower Mode D'emploi

5.3 Operating elements

The operating elements and connectivity are located on the front side of the filter
component:
- I / O switch (pos. 1)
Use this switch to turn the filter system on or off.
The green illuminated ring around the switch indicates trouble-free operation
of the filter system. If there is a fault or an error, the green lamp goes out and
the filter unit switches off automatically.
- Signal lamp (item 2)
The yellow signal light indicates an issue or an error in the filter system. These
faults are shown with different flashing codes for a visual depiction.
The signal lamp flashes steadily in regular intervals:
-The equipment is due servicing; inform Kemper service.
The signal lamp flashes briefly twice in a row in regular intervals:
-The frequency converter has a fault, inform KEMPER service.
The signal lamp flashes briefly 4 times in a row at regular intervals:
- Compressed air error, check required compressed air supply.
- Service button (item 3)
Only to be used by KEMPER service.
- "IFA, flow" metering connection (item 4)
Only to be used by KEMPER-Service.
Part no.: 150 2627 (CAT 2.0)
All rights over changes without prior notice and errors reserved.
KEMPER CleanAirTower 2.0 Operating instructions - EN
- 65 - Rev.: 00
Issue: 02/2017