Crane Eyelets In The Fan Component - Kemper Clean Air Tower Mode D'emploi

Information
The operator may not move the entire filter system using the crane
eyelets on the suction component. The components must be removed
separately. Afterwards, they can once again be reassembled at the
new location.

5.2 Crane eyelets in the fan component

There are four crane eyelets (item 1) inside the fan component for transporting it.
When assembling the filter unit, the components must be transported separately to
the desired installation site.
Part no.: 150 2627 (CAT 2.0)
All rights over changes without prior notice and errors reserved.
KEMPER CleanAirTower 2.0 Operating instructions - EN
Figure 9, Transport eyelets on the fan component
- 64 - Rev.: 00
Issue: 02/2017