Preparation
Bottom cover lock bar
Open
Replace
CR2
Lithium battery
Tape to remove the battery
34
Opening Bottom cover
Remove the cover by sliding it to
Ç
the direction of Arrow
, while
pushing the Bottom cover lock bar
Å
to the direction of Arrow
.
Replacing Bottom cover
Set the cover as shown and slide it
toward the camera front (Arrows)
till it clicks in place.
* The cover can be removed from
the camera. Be careful not to
misplace it !
Inserting Battery
Put the battery as shown, minding
the battery polarity (as shown),
placing it over the tape so that the
tip of the tape juts out.
Removing Battery
Pull the tape to remove the
battery.
miniSD card
Open
Close
Inserting miniSD card
With the Bottom cover removed
insert the card all the way as
shown.
Removing miniSD card
Push the card further to make
it spring back.
Opening Viewfi nder hood
Hold both sides of Viewfi nder cover
Å
as shown and lift the cover up
.
Closing Viewfi nder hood
Close the hood while pressing
inward the hinges on both sides of
Ç
the hood as shown
.
35