GiBiDi SL Série Mode D'emploi page 15

SL
FITTING THE LIMIT SWITCHES [15]
u
1-insert the nuts in the hexagonal seats on the magnet holder
2- insert the grub screw and nut
least 1-1.5 mm;
3- insert the adjusting screw and nut
e
4- assemble the bracket
NOTE: at this stage, it is sufficient to assemble the unit to then position it on the rack without having to tighten the
screws.
5- Position the complete limit switches on the rack in the appropriate positions.
NOTE: the limit switch marked on the cover with the letter "O" must be secured in correspondence to the gate-open
position and the one marked "C" in the gate-closed position [18]. To ensure this condition in applications where
the motor is installed on the "left" [18] invert the motor power cables.
Note with reference to Figure [18]
C2: Limit switch "C" Motor off during closing
C1: Limit switch "C" Deceleration start during closing
O2: Limit switch "O" Motor off during opening
O1: Limit switch "O" Deceleration start during opening
6- To fasten the limit switch, first tighten the two screws
depending on the type of rack and then act on the grub screws
WARNING: Do not overtighten the grub screws
7- Should the limit switch not yet be sufficiently integral with the rack, you can adjust it by unscrewing the screw
WARNING: Do not exceed in this adjustment since you may deform the bracket.
USING THE DECELERATION FUNCTION
If using GI.BI.DI. boards that have the deceleration control function, remember to position 2 pairs of limit switches as
shown [18].
q
in the magnet holder
y
in the hexagonal seat of the magnet holder
using the screws provided
t
so as not to deform the bracket.
p
;
p
making sure that it protrudes towards the rack
r
and insert the grub screws
r
, then act on the screw
t
to securely lock the bracket to the rack.
w
p
;
t
.
y
to adjust the clamp distance
15
UK
by at
y
.