Warnings For The Installer - GiBiDi SL Série Mode D'emploi

12
UK
INTRODUCTION
The gearmotors SL 400-800 allow easily and quickly automating small to medium-sized sliding gates of up to 800 kg.
The automated device with integrated control unit facilitates system certification in accordance with EN125453.

WARNINGS FOR THE INSTALLER

Ÿ
Before proceeding with installation, fit a magnetothermal and differential switch with a maximum capacity of 10A
upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening
distance of at least 3mm.
Ÿ
All the packaging materials must be kept out of reach of children since they are potential sources of danger.
Ÿ The manufacturer declines all responsibility for proper functioning of the automated device if failing to use original
GIBIDI components and accessories suitable for the intended application.
Ÿ
When installation has been completed, always carefully check proper functioning of the system and the devices
used.
Ÿ
This instruction manual addresses persons qualified for installation of "live equipment", therefore, good technical
Ÿ
knowledge is required exercised as profession in compliance with the regulations in force.
Ÿ
Maintenance must be performed by qualified personnel.
Ÿ
Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
Ÿ
This product has been designed and constructed solely for the use indicated in this document. Any other use may
cause damage to the product and be a source of danger.
Ÿ
Verify the intended end use and take the necessary safety precautions.
Ÿ
Use of the products for purposes different from the intended use has not been tested by the manufacturer and the
operations performed are therefore on full responsibility of the installer.
Ÿ Mark the automated device with visible warning plates.
Ÿ
Warn the user that children and animals must not play or stand near the gate.
Ÿ
Adequately protect the danger points, for example, using a sensitive frame.
Ÿ
Check proper installation of the earthing system; connect all the metal parts of doors, gates, etc. and all the
system components equipped with earthing plate.
Ÿ
Exclusively use original spare parts for any maintenance or repair.
Ÿ
Do not make any modification to the components of the automated device unless expressly authorised by GIBIDI.
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
It is important for the safety of persons to follow these instructions.
Keep this instruction manual.
SL