Corghi EYE LIGHT Manuel D'utilisation page 59

NOTE
If the laser sensors and/or telecamera fails to
operate, the geometric data can be entered
manually by following the procedure indicated
in the "Manual wheel data entry" section. This
function is present in the Utility and Configura-
tion programmes.
NOTE
The laser sensors may not measure the rim
dimensions correctly on particularly reflective
surfaces. In this case enter the geometric data
manually following the procedure described in
the paragraph "Manual wheel data entry", which is
a function present in the Utility and Configuration
programmes. In this circumstance, at the end of
the spin, the machine will automatically set up so
the diameter can be entered (see figure), whereas
the distance and width are present but must be
checked for correctness and changed if necessary.
The balancing weights must always be applied at
12 o'clock, regardless of the selected programme.
CAUTION
bear in mind that the nominal wheel diameter
(e.g. 14") refers to the planes on which the tyre
beads rest which are obviously inside the rim.
On the other hand, the data measured refer to
external planes, so they will be lower than the
rated values because of the thickness of the
rim. The correction value therefore refers to
an average thickness of the rim. This means
that the data measured on wheels with differ-
ent thicknesses may vary slightly (2 or 3 tenths
of an inch maximum) from the rated values.
This is not a lack of accuracy of the measuring
devices, but reflects reality.
EYE LIGHT - Operator's manual
WARNING
Do not operate the machine without the guard
and/or if the safety device has been tampered
with.
WARNING
Never raise the guard before the wheel has
come to a stop.
WARNING
At the end of the spin, the machine will open the
wheel guard automatically, therefore do NOT
stand in the range of operation of the guard.
WARNING
If the wheel keeps spinning permanently due to
a fault on the machine, switch off the machine
using the main switch or disconnect the plug
from the power supply board (emergency stop)
and wait until the wheel stops before raising
the guard.
Dynamic balancing (Dynamic)
This balancing mode is the most commonly used
one. If a different balancing programme is run-
ning, the programme must be set by selecting
the correct icons.
Now proceed as follows:
- Press the Dimensions button
enable automatic dimension measurement.
The button remains pressed and the inner
light turns red
- Spin the wheel by lowering the guard.
To ensure accurate results, do not apply undue
stress to the machine during the spin and do
not interfere with telecamera and laser sensor
scanning.
- Wait for the wheel to stop automatically (the
wheel guard will raise up automatically) and
the display of the image taken by the camera
showing the start of the rim, detected auto-
to
UK
.
59