Important - Corghi EYE LIGHT Manuel D'utilisation

the floor and the envisaged fixing means must
also be taken into account.

IMPORTANT:

for the correct and safe operation of the machine,
the lighting level in the place of use should be
at least 300 lux.
Environmental operating conditions must comply
with the following requirements:
- Relative humidity ranging from 30% to 80% (without
condensation).
- Temperature ranging from 5° to +40°C.
WARNING
The machine must not be operated in potentially
explosive atmospheres.
The machine is supplied partially disassembled
and is to be assembled according to the proce-
dures described below.
Monitor support and monitor
touchscreen assembly
- fix the monitor support (A, fig.4) to the weight
tray and to the casing using the six screws sup-
plied with the machine (fig.4);
- insert the monitor's USB cable, the signal cable
and the power supply cable inside the previ-
ously mounted support, as shown in figure 5;
46
- fix the closing plate (A, fig.5) using the eight
screws (V, fig.5) supplied with the machine;
- Remove the monitor from its packaging and
remove the support base, if necessary.
- Fix the monitor to the wheel balancer support
flange using the four screws supplied with the
machine (A, fig 6).
A
B
- connect the USB, signal and power supply
cables to the rear monitor panel (B,C,D, fig. 6).
4
EYE LIGHT - Operator's manual
V
A
5
C
6
D