BALANCING
PROGRAMMES
At start-up, by default, the wheel balancer ex-
ecutes the Dynamic programme which uses clip
weights on both sides.
The balancing programmes can be recalled by
simply selecting on the touchscreen the icon
for the weight according to the type of rim and
professional experience:
if the weight to be applied is a spring type
or
if the weight to be applied is adhesive.
Each combination of weights corresponds to a
specific balancing programme that will be dis-
play in the top part of the screen (e.g.. dynamic,
alu1, etc.).
Note: a different type of weight can also be se-
lected at the end of the dimension measurement
and unbalance calculation cycle.
Note: the Static programme, that uses only one
weight, is activated by selecting the icon for the
desired weight on the touchscreen and disabling
the icon that is not required.
POSITION INDICATORS AND
ALARM INDICATOR LIGHTS
The wheel balancer has two round indicators for
the positioning of unbalances.
Each indicator has a button for changing the
unbalance unit of measurement from grams to
ounces and vice versa.
54
By selecting the central part of the indicator, an
automatic centred position search starts if the
unbalance is higher than zero.
At the end of the dimension and unbalance
measurement cycle, warning indicators may
come on if the set acceptable tolerances are
exceeded (see the "Wheel balancer parameter
configuration" section):
1.
WARNING OPT
This recommends performing the unbalance
optimisation procedure. Select the icon to
start the unbalance optimisation procedure
(see the "Unbalance Optimisation pro-
gramme" section).
2.
WARNING ROD
This recommends performing the RUNOUT
analysis procedure. Select the icon to display
the radial runout measurement of the wheel
assembly when the icon is selected, the radial
run-out measured for the wheel assembly is
displayed if a wheel assembly is mounted,
or the radial run-out at the seats of the tyre
bead if a rim only is mounted (see the "Runout
programme" section).
3.
This indicates that the clamping brake is on.
To disable it, press the Stop button
or wait 50 seconds.
SPIN TYPE
The working environment has different spin
types that the operator can select based on his
requirements, i.e.:
•
wheel unbalance detection and
radial run-out acquisition of the complete
wheel
EYE LIGHT - Operator's manual