Feedback Window - Corghi EYE LIGHT Manuel D'utilisation

or optimised mode for slow vehicle
wheels;
press the button again to deactivate the
Weight Management suite.
Wheel balancing is performed using the
desired balancing programme. At the end
of the spin, if wheel balancing is considered
satisfactory, the position indicators will dis-
play the icons
indicators for indicating the residual rotation
torque unbalance level (left indicator) and
static rotation torque level (right indicator).
2.
selects the required operator:
- This button can be used to change operator
quickly.
- 3 operators can be selected (1, 2 or 3) and
named (see the "Customisation" section).
- When a new operator is selected, the machine
resets the parameters that were active at the
last recall.
The stored parameters are:
- Balancing mode; Dynamic, ALU, etc...
- Wheel dimensions.
- Last phase of OPT.
- General machine settings: grams/ounces,
sensitivity x5/x1, etc...
3.
enables/disables the iPos programme (intel-
ligent positioning):
- Selecting the following button defines the
wheel to be analysed:
- selects the front left wheel;
- selects the front right wheel;
- selects the rear right wheel;
- selects the rear left wheel;
pressing the button again to disable the iPos
programme.
Once the data acquisition procedure is com-
plete, the programme suggests the optimal
position of the wheels on the vehicle.
For more detailed information refer to para-
56
and two semicircular
graph 3.3 of the "Wheel Diagnosis Programme"
suite.
4.
Enables/disables the unbalance display
mode (gx1 or gx5).
- Select this button to display the unbalance
mass in grams:
to the nearest gram or 1/10 of an ounce
if the unit of measurement has been set to
ounces;
or to the nearest 5 grams or 1/4 of an
ounce if the unit of measurement has been
set to ounces.
This function is not enabled in the ALU1 and
ALU2 programmes (see the "Shift Planes pro-
gramme" section).
5.
print menu:
- Select this button to access the print menu
for the programme that is running.
The following is possible in the menu:
- Fill out the empty fields in the report by
pressing the text Entry button
- Start the print process with the Print button
.

FEEDBACK WINDOW

The feedback window, as shown in the figure
below, displays the following information:
- Name of operator (see the "Customisation"
section).
- Time (see "Wheel balancer parameter con-
figuration" section).
- Wheel dimensions during the last spin: white
if measured automatically; or yellow if set
manually.
EYE LIGHT - Operator's manual
.