B. Timer clock setting
This function allows the system to turn on automatically and wake you up by CD, DAB, FM Radio, USB mode respectively.
First, set the unit at standby mode and then press & hold the "Timer" button (18) to enter the setting mode, the LCD display will
show "SET TIMER" then change to "SELECT SOURCE and timer"
Wake up source: press the "Function" button repeatedly to select the source from "CD" -- "FM" -- "DAB"-- "USB". Press
1)
"Timer" button to confirm the selected source.
Wake up volume: press the skip/preset up-down button (14/15) to adjust the wake up volume level then press "Timer" button
2)
(18) to confirm the wake up level.
Wake up time: press "Skip up
3)
Press "Skip up
/down
Remark
If there is no music source being detected (such as USB/CD) when the preset time is reached, system will default to FM
mode automatically.
For FM or DAB radio wake up, the system will preset at the latest radio frequency being listened before switching off.
Please switch off the system manually during alarm wake up mode as the system will not turn off automatically after alarm
on mode.
Active/de-active timer function
To active the timer, press once the "Timer" button on remote handset until the timer indicator "
1.
(6).
To cancel timer function by press once again "Timer" button until the timer indicator "
2.
C. Pre-set EQ function
This unit provides 4 differences sound mode to enhance your listening experience. You can select the desired effect by pressing
the "Preset EQ" button (22) repeatedly at following sequence:
FLAT
CLASSIC
In addition, there is a "MY EQ" setting which allows you to set your desired sound effect.
Hold the "EQ" button (22)
1)
The display will show "Bass set", turn the volume +/- knob (17) to adjust the bass level.
2)
Press "EQ" button (22) again to confirm.
3)
Then the display will show "Treble", turn the volume +/- knob (17) to adjust the treble level.
4)
Press "EQ" button (22) again to confirm.
5)
Factory Reset
Select " DAB " mode
1.
Press & hold the " PLAY-MODE " key at remote control for 5 seconds.
2.
Remark: Due to ErP stage two requirements and protect the environment. The unit will
switch to standby mode automatically once no any music playing over 15 minutes.
Specification
UKW/FM:
DAB+ Band III:
®
Bluetooth
:
Power Supply:
Power consumption:
" button (14/15) to set the hour & then press "Timer" button to enter the hours.
/down
" button (14/15) to set minutes and press "Timer" button to store the memory.
ROCK
POP
87.5-108 MHz
174 – 240 MHz
2402 – 2480 MHz (+/- 75KHz) / max. transmitted power 2 dBm
AC230V~50Hz
33W
NR546 / English Instruction Manual
icon will flash on display:
" disappears.
JAZZ
" is shown on LCD display
9