Filter And Filter-Holder Cleaning - Astoria AL Série Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
7.6.2 Cappuccino-maker wash
Use special care in cleaning the cappuccino maker,
following the procedures indicated below:
perform a first washing by immersing the suction
tube in water and run a delivery for a few seconds;
turn the rotating body (X) 90° to position B (closure
of milk outlet duct);
holding the milk suction tube in the air, dispense
steam (cappuccino maker dry run);
wait about 20 seconds to allow for internal cleaning
and sterilisation of the cappuccino maker;
close the steam and put the rotating body back in
position A;
if the air intake hole (Y) is blocked, clear it gently
with a pin.
Position A
X
Clean the cappuccino maker after each continuous use and at
least once a day.

7.6.3 Filter and filter-holder cleaning

Daily:
Soak the filter and filter-holder in hot water overnight
so that the fatty coffee deposits can dissolve;
rinse with lukewarm
water.
Weekly:
Use a screwdriver to de-
tach the filter from the
filter holder;
Soak the filter and filter
holder in warm water and cleaning agent for 10
minutes.
rinse with lukewarm water.
Caution: Only immerse the filter holder cup, avoid soaking the
handle in water.
The detergent must be diluted in cold water in the doses indicated
on the package (see manufacturer).
USER manual
Y
Position B
7.6.4 Washing of dispensing unit (excluding AL version)
Wash the dispensing units daily, as specified here-
under:
From the filter carrier, remove the filter and fit a blind
filter (see spare parts);
Pour the specific deter-
gent (see spares) in the
filter carrier with blind
filter and hook it to the
dispensing unit;
command some dispens-
ing cycles until clean wa-
ter will come of the drain;
remove the filter carrier
from the unit and carry out
at least one dispensing
cycle so as to eliminate the detergent residue.
Remove the blind filter from the filter carrier, replacing
it with the original one.
Do not wash the unit in case of the AL version.
7.6.5 Perforated disk and containment ring cleaning
Weekly perform the cleaning of the Perforated disk
and containment ring in the
following way:
Loosen the screw (1);
remove the perforated
disk (2) and the contain-
ment ring (3);
carefully wash the two
components with hot
water;
replace perforated disk
and containment ring
to its original position by
locking everything with
the screw.
3
2
1
45
160
of

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Aep sérieSae série

Table des Matières