Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.5.2 Cappuccino maker wash
Take special care when cleaning the cappuccino
maker and follow the steps provided below:
• Perform an initial wash by immersing the suction
hose into the water and dispensing for a few seconds;
• turn the rotating body (X) 90° to position B (closure
of milk outlet duct);
• holding the milk suction tube in the air, dispense
steam (cappuccino maker dry run);
• wait about 20 seconds to allow for internal cleaning
and sterilisation of the cappuccino maker;
• close the steam and put the rotating body back in
position A;
• if the air intake hole (Y) is blocked, clear it gently
with a pin.
Position A
X
Clean the cappuccino maker after each continuous use and at
least once a day.
8.5.3 Filter and filter holder cleaning
Daily:
• Soak the filter and filter holder in hot water overnight
so that the fatty coffee deposits can dissolve;
• rinse with lukewarm
water.
Weekly:
• Use a screwdriver to de-
tach the filter from the
filter holder;
• Soak the filter and filter
holder in warm water and cleaning agent for 10
minutes;
• rinse with lukewarm water.
Caution: Only immerse the filter holder cup, avoid soaking the
handle in water.
The detergent must be diluted in cold water in the doses indicated
on the package (see manufacturer).
78
288
of
Y
Position B
8.5.4 Dispensing group wash for the AEP version
Wash the dispensing groups daily as indicated below:
• Remove the filter from the filter holder and fit a blind
filter (see spare parts);
• pour the special detergent (see spare parts) into the
filter holder with the blind filter and hook it to the dis-
pensing group;
• dispense until
the water comes
out clean;
• Remove the filter
holder from the
group and carry
out at least one
dispensing cycle in order
to eliminate any detergent
residues.
• Remove the blind filter from
the filter holder and replace
it with the original one.
8.5.5 Dispensing group wash for the SAE and DISPLAY
version
Wash the dispensing units daily, as specified here-
under:
• Remove the filter from the filter holder and fit a blind
filter (see spare parts);
• pour the special detergent (see spare parts) into the
filter holder with the blind filter and hook it to the
dispensing group;
• On the push button panel of the group being washed,
simultaneously hold down the
for at least 10 seconds;
• Wait for the 5 wash cycles to be carried out;
• Remove the filter holder and press the
start the give or take 30-second rinsing cycle.
Those in possession of the AL version of the machine must not carry
out a group wash cycle.
and
buttons
button to
USER manual
Publicité
Chapitres
Table des Matières
