System Setting - Tripp-Lite B300-9X2-4K Manuel De L'utilisateur

Operation

System Setting

Note: Default settings are indicated in bold.
KB/Mouse
USB
Peripheral
Source
Audio I/O
Mute
Auto Switch
Source 1
Source 2
Source
Source 3
EDID
Firmware Upgrades
Maintenance
Reset to Default
Exit
Sets the source that can be controlled by the console keyboard and
mouse.
• Auto
Note: The source must also be assigned to Display A for this function to work.
• Source 1
Select Auto to allow Source 1 or Source 2 to be controlled by the
• Source 2
console keyboard and mouse, depending on which source is assigned
to Display A.
Sets the source that has access to the USB peripherals. The selected
source must also be assigned to Display A for this function to work.
• Auto
Select Auto to allow either Source 1 or Source 2 to access the
• Source 1
attached peripherals, depending on which one is assigned to Display A.
• Source 2
Note: The source device must be a laptop, PC or tablet, and connected to the
USB host port on the unit. For details on the required setup, refer to Operating
PCs/Laptops/Tablets.
• Display A
Sets the audio source.
• Display B
• All
• S/PDIF / Coaxial Sets the allowed output type (stereo, digital, or both).
• L/R
• Enable
Mute or unmute the unit.
• Disable
• ON Enables this function to have Display A automatically switch to a newly
• OFF connected source.
• Auto Sets the input source for Source 1. Select Auto to allow input from the
connected HDMI or VGA source. When Auto is selected, the input
• HDMI
• VGA defaults to the HDMI source.
• Auto Sets the input source for Source 2. Select Auto to allow input from the
• HDMI connected HDMI or DisplayPort source. When Auto is selected,
• DisplayPort the input defaults to the HDMI source.
• Auto Sets the input source for Source 3. Select Auto to allow input from the
connected HDMI or AV/YPbPr source. When Auto is selected, the input
• HDMI
• AV / YPbPr defaults to the HDMI source.
Display A: Sends EDID information of Display A to the sources.
• Display A
Remix: Sends optimum EDID among the connected displays to the
• Remix
sources.
• Default
Default: Sends the predefined EDID to the sources.
Upgrades the unit firmware.
Note: Save the firmware file to a USB drive and plug it into the unit before
performing an upgrade.
Sets the unit to its default settings.
Closes the OSD.
Description
11