Tripp-Lite B300-9X2-4K Manuel De L'utilisateur page 13

Operation
Commands
- System Firmware Version Command
version
Function: Display the firmware version of the B300-9X2-4K-
read
Function: Display the EDID mode for all output ports, the system information (device name, vendor, serial number,
hardware version, build version) for the B300-9X2-4K and network settings.
- Source Switching Command
sw i<input_port> o<output_port>
Function: Switch the source on specified display to the specified source.
Parameters:
o i<input_port>
Description: Specify the input port of the target source. When this parameter is omitted, the system takes on the value of
01 (input port 1).
Format: 01 – 06
o o<output_port>
Description: Specify the output port of the target display. When this parameter is omitted, the system takes on the value of
01 (Display A).
Format: 01=Display A, 02=Display B, *=Both Display A & B.
Examples:
Type sw i03 o02 to switch the source on Display B to the source connected to input 3.
Type sw i05 to switch the source on Display A to the source connected to input 5.
Type sw o02 to switch the source on Display B to the source connected to input 1.
- Auto Switching Command
swmode next | off
Function: Sets all input ports to auto switching. Display A will be automatically switched to any newly connected source.
swmode i<input_port> next | off
Function: Set the specified combo port (Source 1, 2, or 3) to auto switching. If Display A is showing a source from a combo
port (Source 1, 2, or 3) and a new source is plugged into that same combo port, Display A will be automatically switched to
the new source.
Parameters:
o next
Description: Enable auto switching
o off
Description: Disable auto switching
o i<input_port>
Description: Specify the input port of the target source.
Format: 01 – 03
Examples:
Type swmode next to set all input ports to auto switching. When a new source is plugged into any input port on the matrix
switch, Display A will automatically switch to the new source.
Type swmode i02 next to set combo port 2 (Source 2) to auto switching. When a new source is plugged into combo port 2
(Source 2), Display A will automatically switch over to the newly connected combo port source.
Read Command
13