Leister GROOVER 500-LP Instructions D'utilisation page 32

6.1 Setting the groove depth
17
18
19
The straight top edge of the indicator (17) shows the groove depth on the scale (18). To set the groove depth,
use the adjusting screw (19). As a rough guide, use two thirds of the covering thickness and up to half
the wire diameter. However, the specifications provided by the manufacturer always take priority. Check the
groove depth by carrying out a grooving test.
6.2 Adjusting the guide and rear guide rollers
Align the guide roller (9) and rear guide roller (20) centrally in relation to the cutter blade. To adjust the position
of the rollers, use an open-end wrench to loosen the narrow hexagon nut on the base plate. If you need to change
the rollers, you can remove them completely by loosening the narrow hexagon nut with the open-end wrench and
then using a size 5 hexagon key (15).
6.3 Adjusting the side roller for pimpled flooring
For pimpled flooring, move the side roller (15) if necessary. To do this, loosen the screw with the size 5 hexagon
key (16) and move the side roller (15) to the required position. Then retighten the screw.
32
15
Center of cutter blade mark
20 9
Screw
15